正确连接济南音响调音台，音色如水般清澈
2014-9-19 9:37:37 点击：
提到音响系统，我们当然首先会想到调音台。形象的来说调音台就像一个大的水处理池，我们把多种音源信号像流水一样输入进这个大水池，然后在水池内对流入的各种水进行合理的处理，最后再从各种不同渠道流出去，整个过程就是这么简单。因此对调音台的连接无非也是：输入和输出两大部分。
Mention sound system, of course we will first think of mixer. Image is the mixer is like a big water treatment pool, we have a variety of audio signal like water input into the large pool, then the reasonable processing for various water inflow in the tank, then from various channels going out, the whole process is so simple. Therefore the connection of the mixer is nothing more than two parts: input and output.
一、济南音响调音台输入部分的线路连接：
A, Ji'nan audio mixer input part of the line connection:
调音台的输入信号大体上分为低阻话筒信号输入和高阻线路信号输入两种。其实我们可以把低阻和高阻的区分看成是水压力或水流速度的不同。
Input signal mixer is generally divided into low impedance microphone signal input and a high impedance line signal input two. In fact, we can take the low resistivity and high resistance to distinguish as water pressure or flow velocity difference.
只有分清高阻、低阻之后才可以选择正确的线材进行相应的连接，大体上济南音响调音台输入插口基本可以分为3种：
Only then to distinguish between high resistivity, low resistivity can select the correct wire for the corresponding connection, generally Ji'nan input audio mixer faucet can be basically divided into 3 types:
1、TRS：高阻输入部分通常要用6.35cm TRS立体声接头作平衡输入，尽量不要用6.35 TS单音(声)接头作非平衡输入，而现在我们用的大部分音源播放设备如：CD、VCD、DVD、MD、MP3等以及大部分乐器的输出信号通常都是高阻信号。
1, TRS: the high impedance input part usually use 6.35cm TRS stereo joint for balance input, try not to use 6.35 TS tone (sound) joint for the unbalanced input, and now we use most audio playback equipment such as: the output signal CD, VCD, DVD, MD, MP3 and most of the instruments are usually the high impedance signal.
2、XLR：而低阻通常用XLR卡侬接头作平衡输入，现在大部分的有线话筒通常都要用低阻插口与调音台连接。
2, XLR: low resistivity XLR XLR connector used for balanced input, wired microphone now most usually with low resistance socket is connected with the mixer.
3、RCA：如果有的调音台带有TAPE录音输入，那通常是采用RCA莲花接头进行连接。
3, RCA: if some mixer with TAPE audio input, which is usually used to connect RCA lotus joint.
二、济南音响调音台输出部分的线路连接：
Two, Ji'nan audio mixer output part of the circuit connection:
现在专业济南音响 http://www.jnzqyx.com/ 调音台的输出部分有很多插口，而且各有分工,不像输入部分虽然插口多但却相对简单。因此连接输出信号时要慎重。通常调音台主要的输出部分还是指总音量输出、编组音量输出、AUX输出等，大体上调音台输出部分按功能分一般可以分6个部分：
Now the output part of the professional Ji'nan audio mixer has a lot of socket, and each division, unlike the input part although Jack but relatively simple. Therefore, connecting the output signal should be carefully. Usually the main output of mixer or a total volume output, marshalling volume output, AUX output, generally console output parts according to the function can generally be divided into 6 parts:
1、编组输出：如果我们把低音音箱通过1-2编组来单独控制音量，那么就只能从调音台1-2编组相对应的输出插口输出音频信号，编组输出的输出口大多数采用TRS立体声插口作平衡输出，当然也有的用卡侬插口。
1, group output: if we take the bass sound box to separate the control volume by 1-2 marshalling, output socket of the output audio signal then only from the mixer 1-2 grouping corresponding to the output port, the output grouping with most TRS stereo jack for balanced output, there are of course with XLR connectors.
2、主声道输出：L-R主声道通常采用XLR卡侬平衡输出，有些小型调音台也有用TRS立体声插口代替的。
2, the main channel output: L-R main channel usually use XLR XLR balanced output, some small mixer also useful TRS stereo jack instead.
3、AUX输出：调音台中AUX输出最常用是输出给人声效果器的,其次是用来给乐队或歌手提供监听信号，当然也开以有别的用途，如：录音、用作辅助音箱信号等。AUX通常采用TRS立体声插口输出信号。
3, the AUX output: console AUX most commonly used output is output to the vocal effects, the second is used to provide monitoring signal to the band or singer, of course, open to have other uses, such as: recording, used as auxiliary speakers signal etc.. AUX usually uses TRS stereo jack output signal.
4、Direct直接输出部分：比较专业的调音台每个输入通道里还有一个“Direct直接输出”插口，这个插口可以提供给另外的设备用来录音、监听等，调音台的每通道通常是采用TRS立体声插口输出信号的。
4, Direct direct output part: console each input channel more professional there is a "Direct output directly" Jack, the jack can provide additional equipment used for recording, monitoring, each channel mixer is usually uses TRS stereo jack output signal.
5、录音输出：一般的模拟录音输出信号插口大都采用RCA莲花接头。如果是数字信号那可能采用光纤、火线等其它数字输出方式。
5, recording output: analog recording output signal socket general mostly use RCA lotus joint. If it is a digital signal that may be using optical fiber, wire and other digital output.
6、INS插入插出插口：调音台里的这种插口介于输入和输出之间，它采用TRS立体声接头进行连接。关于INS插入插出好多音响师可能还不会用,它可以将某周边设备插入到调音台某一输入通道、编组通道或主(左右声道)通道中，单独对所插入通道的声音信号进行处理。
6, the INS is inserted between a jack: mixer in this socket between input and output, it uses TRS stereo joint connection. About INS to insert the many audio division may not be used, it can be a peripheral device is inserted into a mixer one input channel, marshalling channels or main (left channel) channel, on the insert alone channel sound signal processing.
Mention sound system, of course we will first think of mixer. Image is the mixer is like a big water treatment pool, we have a variety of audio signal like water input into the large pool, then the reasonable processing for various water inflow in the tank, then from various channels going out, the whole process is so simple. Therefore the connection of the mixer is nothing more than two parts: input and output.
一、济南音响调音台输入部分的线路连接：
A, Ji'nan audio mixer input part of the line connection:
调音台的输入信号大体上分为低阻话筒信号输入和高阻线路信号输入两种。其实我们可以把低阻和高阻的区分看成是水压力或水流速度的不同。
Input signal mixer is generally divided into low impedance microphone signal input and a high impedance line signal input two. In fact, we can take the low resistivity and high resistance to distinguish as water pressure or flow velocity difference.
只有分清高阻、低阻之后才可以选择正确的线材进行相应的连接，大体上济南音响调音台输入插口基本可以分为3种：
Only then to distinguish between high resistivity, low resistivity can select the correct wire for the corresponding connection, generally Ji'nan input audio mixer faucet can be basically divided into 3 types:
1、TRS：高阻输入部分通常要用6.35cm TRS立体声接头作平衡输入，尽量不要用6.35 TS单音(声)接头作非平衡输入，而现在我们用的大部分音源播放设备如：CD、VCD、DVD、MD、MP3等以及大部分乐器的输出信号通常都是高阻信号。
1, TRS: the high impedance input part usually use 6.35cm TRS stereo joint for balance input, try not to use 6.35 TS tone (sound) joint for the unbalanced input, and now we use most audio playback equipment such as: the output signal CD, VCD, DVD, MD, MP3 and most of the instruments are usually the high impedance signal.
2、XLR：而低阻通常用XLR卡侬接头作平衡输入，现在大部分的有线话筒通常都要用低阻插口与调音台连接。
2, XLR: low resistivity XLR XLR connector used for balanced input, wired microphone now most usually with low resistance socket is connected with the mixer.
3、RCA：如果有的调音台带有TAPE录音输入，那通常是采用RCA莲花接头进行连接。
3, RCA: if some mixer with TAPE audio input, which is usually used to connect RCA lotus joint.
二、济南音响调音台输出部分的线路连接：
Two, Ji'nan audio mixer output part of the circuit connection:
现在专业济南音响 http://www.jnzqyx.com/ 调音台的输出部分有很多插口，而且各有分工,不像输入部分虽然插口多但却相对简单。因此连接输出信号时要慎重。通常调音台主要的输出部分还是指总音量输出、编组音量输出、AUX输出等，大体上调音台输出部分按功能分一般可以分6个部分：
Now the output part of the professional Ji'nan audio mixer has a lot of socket, and each division, unlike the input part although Jack but relatively simple. Therefore, connecting the output signal should be carefully. Usually the main output of mixer or a total volume output, marshalling volume output, AUX output, generally console output parts according to the function can generally be divided into 6 parts:
1、编组输出：如果我们把低音音箱通过1-2编组来单独控制音量，那么就只能从调音台1-2编组相对应的输出插口输出音频信号，编组输出的输出口大多数采用TRS立体声插口作平衡输出，当然也有的用卡侬插口。
1, group output: if we take the bass sound box to separate the control volume by 1-2 marshalling, output socket of the output audio signal then only from the mixer 1-2 grouping corresponding to the output port, the output grouping with most TRS stereo jack for balanced output, there are of course with XLR connectors.
2、主声道输出：L-R主声道通常采用XLR卡侬平衡输出，有些小型调音台也有用TRS立体声插口代替的。
2, the main channel output: L-R main channel usually use XLR XLR balanced output, some small mixer also useful TRS stereo jack instead.
3、AUX输出：调音台中AUX输出最常用是输出给人声效果器的,其次是用来给乐队或歌手提供监听信号，当然也开以有别的用途，如：录音、用作辅助音箱信号等。AUX通常采用TRS立体声插口输出信号。
3, the AUX output: console AUX most commonly used output is output to the vocal effects, the second is used to provide monitoring signal to the band or singer, of course, open to have other uses, such as: recording, used as auxiliary speakers signal etc.. AUX usually uses TRS stereo jack output signal.
4、Direct直接输出部分：比较专业的调音台每个输入通道里还有一个“Direct直接输出”插口，这个插口可以提供给另外的设备用来录音、监听等，调音台的每通道通常是采用TRS立体声插口输出信号的。
4, Direct direct output part: console each input channel more professional there is a "Direct output directly" Jack, the jack can provide additional equipment used for recording, monitoring, each channel mixer is usually uses TRS stereo jack output signal.
5、录音输出：一般的模拟录音输出信号插口大都采用RCA莲花接头。如果是数字信号那可能采用光纤、火线等其它数字输出方式。
5, recording output: analog recording output signal socket general mostly use RCA lotus joint. If it is a digital signal that may be using optical fiber, wire and other digital output.
6、INS插入插出插口：调音台里的这种插口介于输入和输出之间，它采用TRS立体声接头进行连接。关于INS插入插出好多音响师可能还不会用,它可以将某周边设备插入到调音台某一输入通道、编组通道或主(左右声道)通道中，单独对所插入通道的声音信号进行处理。
6, the INS is inserted between a jack: mixer in this socket between input and output, it uses TRS stereo joint connection. About INS to insert the many audio division may not be used, it can be a peripheral device is inserted into a mixer one input channel, marshalling channels or main (left channel) channel, on the insert alone channel sound signal processing.
- 上一篇：检修济南音响扩声系统，让设备无忧运行 2014/9/22
- 下一篇：解析济南音响频率范围和频率响应 2014/9/18
